Fagor 8025 t cnc User Manual

When trying to move an axis faster than the maximum feedrate allowed (machine parameter "P110, P310"), the CNC
will limit the actual feedrate to that parameter value ignoring the additional pulses, thus, avoiding following error
messages.

Each axis will move as its associated handwheel is turned, reversing its direction as the handwheel turning direction
is reversed and according to the selected MFO switch position.

When trying to move an axis faster than the maximum feedrate allowed (machine parameter "P110, P310"), the
CNC will limit the actual feedrate to that parameter value ignoring the additional pulses, thus, avoiding following
error messages.

The screen saver function works as follows:

After 5 minutes without pressing a key or without the CNC refreshing the screen, the screen goes blank. Press any
key to restore the display.

Machine parameter "P619(5)" indicates whether this feature is to be used or not.

P619(5) = 0

This feature is not being used.

P619(5) = 1

This feature is being used.

From this version on, machine parameter P812 sets the axis jogging feedrate selected by the CNC when accessing the
JOG mode.

If while in JOG mode, the conditional input (block skip), pin 18 of connector I/O1, the CNC does not allow entering
a new F value. Only the feedrate override (%) may be varied by means of the MFO switch.

Whenever the conditional input (block skip), pin 18 of connector I/O1, the CNC will ignore the rapid traverse key

Machine parameter "P620(8)" indicates when the M3, M4, M5 functions are sent out while accelerating or decelerating
the spindle.

From this version on, it is possible to execute a "T.0" type block inside the subroutine associated with the tool to cancel
the tool offset. This lets move to a particular position  without the need for cumbersome calculations.

Only the tool offset may be canceled (T.0) or modified (T.xx). The tool cannot be changed (Txx.xx) inside the
subroutine associated with the tool.