Liebherr EWTNes 2956 User Manual

WF1051 / EWTNes 2956

11

R

EVERSING

 D

OOR

 H

INGES

10. Figure 6: Lift up cover (3) on handle side, push 

outward; lift up cover (1) on hinge side and pull 
off.

11. Unscrew mounting plate (21): first mounting 

screw (20), then inner retaining screw (25).

 - Unscrew hinge (4): first remove the mounting 

screw (20), then retaining screws (25). Fit 
hinge (4) to opposite side: for easy assembly, 
fit hinge from above and first tighten with the 
upper retaining screw (25) M5, then screw 
(25) and finally mounting screw M4 (20).

  -  Turn mounting plate (21) through 180° and 

screw tight again on the new handle side: first 
retaining screw (25), then mounting screw 
(20).

12. Transfer hinge pin and screw to the respective 

opposite side of the hinge (4), but do not insert 
them in the hole or fasten them now.

13. On the upper door, install the door fittings as 

shown in Figure 6. Insert the plugs (X) as 
shown in the detailed drawing.  Move plug (W) 
to the opposite side of the door.

14. Place the upper door on the center hinge, fit the 

bushing (8), stop (7) and washer on the door, 
swivel in the door at the top and insert and 
secure the hinge pin (2) from above through the 
hinge and stop. Insert screw (6) for fixing the 
opening angle to 130°.

Check for proper alignment of all doors. Adjust 
them if necessary using the slots on the hinge.