IBM 09-0572-000 User Manual
3-4
C
HAPTER
3: U
SING
THE
A
UTO
L
INK
F
EATURE
FOR
N
ET
W
ARE
Using the AutoLink Feature
Follow these steps to use the AutoLink feature:
1 Place the
TokenDisk diskette in a floppy drive on your PC
and make that drive the active drive. For example, type:
A: [Enter]
2 Type at the prompt:
AUTOLINK [Enter]
The first time you use the TokenDisk diskette, the 3Com
software license appears.
software license appears.
3 To accept the terms and conditions of the 3Com end-user
software license agreement, type:
Y
To view the full text of the license agreement, press [F1].
A status message appears, followed by a prompt asking for
the ring speed of your network.
the ring speed of your network.
4 Enter the correct ring speed and configuration mode and
press [Enter].
This adapter can run at 16 or 4 Mbps. The ring speed for the
adapter and the network must be the same. Ask your system
administrator for the correct ring speed.
adapter and the network must be the same. Ask your system
administrator for the correct ring speed.
Upon successful completion, a message appears, stating that
the AutoLink program has completed the configuration.
the AutoLink program has completed the configuration.
5 Remove the
TokenDisk diskette and press any key to
reboot your PC.
The login prompt for a NetWare server appears.
6 Log in to the NetWare server using your user ID and
password provided by your network administrator.
The 3C619C adapter is now a NetWare DOS ODI client.
Installation and configuration are complete. If you have
problems, see Chapter 7, “Troubleshooting,” for help.
Installation and configuration are complete. If you have
problems, see Chapter 7, “Troubleshooting,” for help.