Sterling SSL User Manual
37
To return to the vacuum timer screen:
Press the
SCROLL
SCROLL key again.
The screen reverts to the vacuum timer display.
Resetting the Batch Counter
To reset the batch counter to zero
(
0
)
:
Press and hold both the
CLEAR
UP key and DOWN key together
simultaneously any time the batch counter is displayed.
The batch counter resets to zero (
0
) and the screen reverts to the
vacuum timer display.
5-8 Operating in Single-Shot Mode
1.
Disconnect the Bin Full reed switch sensor and, in its place, wire
a normally closed proximity switch.
a normally closed proximity switch.
2. Install a proximity switch in the machine bin at the highest level
you want the material to reach.
• The Series One Plus controller fills the machine bin until
material covers the proximity switch.
• The screen displays
FULL
until the material level drops
below the proximity switch.
The hopper loader then resumes operation automatically.
5-9 Customizing Series One Plus Controller Operations
The full-feature control gives you complete control over the loading process. You can gain
access to adjustable parameters by using the Series One Plus menu system as shown in Figure
9. You can then fine-tune hopper loader operation at this point to fit the exact requirements of
your process as required.
access to adjustable parameters by using the Series One Plus menu system as shown in Figure
9. You can then fine-tune hopper loader operation at this point to fit the exact requirements of
your process as required.