Siemens 1015N-2MFM-1A User Manual
A-5
1015N-2MFM-1A
Appendix A
“AT” COMMANDS and “S” REGISTERS
EXCLUSIVE TO THE PE2400
Dial Modifiers
Command
Factory Default
Parameters/Description
; (semicolon)
Return to Idle State. “ ; ” forces the modem to remain in the command state after dialing
a number without disconnecting. The semicolon must be placed at the end of the dial
command.
a number without disconnecting. The semicolon must be placed at the end of the dial
command.
Parameters: none
@
WaIt for Quiet Answer Command. ” @ ” causes the modem to look for rings followed by
5 seconds of silence before processing the next symbol in the dialing string. The S7
register value determines the maximum wait time. If quiet answer is detected, the dial
modifiers following the command are executed. If busy is detected, the modem returns
a BUSY result code and goes to the hang-up process, aborting further execution of
commands.
5 seconds of silence before processing the next symbol in the dialing string. The S7
register value determines the maximum wait time. If quiet answer is detected, the dial
modifiers following the command are executed. If busy is detected, the modem returns
a BUSY result code and goes to the hang-up process, aborting further execution of
commands.
Parameters: none
!
Flash Hook Command. “ ! ” causes the modem to go on-hook for 0.75 seconds.
Parameters: none
, (comma)
2 seconds
Pause Command. “ , “ causes the modem to pause for a specified time during dialing.
The S8 register value determines the pause time. Multiple commas may be used to
increase the pause time.
The S8 register value determines the pause time. Multiple commas may be used to
increase the pause time.
Parameters: none
0 to 9, A to D, #, *
Dial Digits/Characters. Characters 0 to 9, A, B, C, D, #, and * are valid. Characters A,
B, C, D, #, and * represent specific tone pairs and, therefore, can be used only when
tone dialing is selected.
B, C, D, #, and * represent specific tone pairs and, therefore, can be used only when
tone dialing is selected.
Parameters: none
W
30 seconds
Wait for Dial Tone. W causes the modem to wait up to a specified time for the dial tone
to occur. The telephone number is dialed immediately upon dial tone detection. The
S7 register value determines the maximum wait time. If a busy signal is detected
instead of dial tone, the modem returns a BUSY result code and goes on-hook,
abandoning subsequent instructions on the command line.
to occur. The telephone number is dialed immediately upon dial tone detection. The
S7 register value determines the maximum wait time. If a busy signal is detected
instead of dial tone, the modem returns a BUSY result code and goes on-hook,
abandoning subsequent instructions on the command line.
Parameters: none