GE NetworX NX-7002 User Manual
NX-7002
LAYOUT AND DESCRIPTION
9
8
1
2
3
4
1
1
11
10
7
5
7
6
DESCRIPTION
1
Future use (VVMIQ)
2
SIM card holder
3
GPRS modem
4
Connect antenna to this connector
5
Header for software upgrade
6
Connect to battery
7
Connect main panel battery leads to these connectors
8
Audio tap connector (CON5)
If the NX-7002 uses the voice channel for event reporting, the special audio cable
If the NX-7002 uses the voice channel for event reporting, the special audio cable
(included) needs to be stuffed between this connector of the NX-7002 and the Audio
Tap connector of the control panel.
9
Keypad bus terminals
10
Status LED’s
GSM in use: ON when events are send over the voice or data channel (Up/download)
PSU error: ON when the modem power source is to low
Reporting: ON when data is reported to the IP receiver or Mobile phone (SMS)
GPRS active: ON when the module is connected to the GPRS network and the first event is
GSM in use: ON when events are send over the voice or data channel (Up/download)
PSU error: ON when the modem power source is to low
Reporting: ON when data is reported to the IP receiver or Mobile phone (SMS)
GPRS active: ON when the module is connected to the GPRS network and the first event is
send. It turns OFF when the module uses the voice channel
SIM error: ON when an incorrect PIN code is entered
GSM com: reserved
Network OK: reserved
Bus com: flashes when communicating on the NetworX bus
SIM error: ON when an incorrect PIN code is entered
GSM com: reserved
Network OK: reserved
Bus com: flashes when communicating on the NetworX bus
11
Green LED: ON when connected to TCP/IP receiver
NX-7002 Installation manual
Page 33
09/02/05