GE NetworX NX-7002 User Manual
S
TART UP
,
ENROLLING AND TESTING THE
NX-7002
Inserting the SIM card
Note: You must be free of all static electricity when handling electronic components.
•
Always power down the system before inserting a SIM Card.
•
Locate the SIM card holder
n
on the board.
•
Open the SIM card holder by sliding the metal clip as shown in
o
and lifting the holder.
•
The SIM card holder opens
p
.
•
Slide the SIM card into the holder using the guides. Make sure the contacts (gold pads)
face the circuit board and the angled corners face out
face the circuit board and the angled corners face out
q
.
•
Ensure the SIM card is inserted correctly in the holder and close the SIM card holder
r
.
•
Slide the metal clip back to the original position as shown in
s
.
•
Power up the system. Do not enter programming mode until the SIM card selects the
network operator. The SIM card automatically selects a network operator when enrolled
on the network. To manually select an operator, enter the relevant network operator in
location 170. See Appendix 2: Operator ID Codes for a list of operator ID codes. Most SIM
cards contain a pre-programmed SMS service centre address and under normal
circumstances, this should not be changed. If you do need to change it, include the
international country prefix using a '+' instead of leading zeros. Program ‘13’ to insert ‘+’
in the address.
NX-7002 Installation manual
Page 10
09/02/05