LG BX503B Owner's Manual

Function

Auto configure Function

Screen Menu Options

* Auto configure is the function that finds optimal video condition by automatically adjusting width and calibration of internal

signal of the projector and various graphic signal of PC in RGB mode.

* Auto configure operates only for RGB input.

When executing auto configure during video playback of PC graphic signal, the projector may not be

able to find optimal video condition. Please execute auto configure in freeze frame.

ꘀ

Prev.

Move

◉ OK

1. Press the MENU button and then use ＜, ＞ button to select the

menu.

2. Press the ∧,∨ button to select auto configure.
• It automatically configures the location of image and calibration.

3. In some cases, auto configure itself cannot find optimal video quality.

If it needs manual adjustment even after auto configure due to various PC mode

input, adjust using phase, clock, horizontal and vertical from the menu.

ꕌ

ꕍ

Auto Configure

Phase                    8
Clock                    0
Horizontal               0
Vertical                    0

Checking lamp time

1. Press the

STILL button of remote control.

• You can freeze the input image.

2. To exit

STILL, press any button .

• The STILL function will release automatically after approximately 10 minutes.

Using Still Function

1. Press the

MENU button and then use

＜

, ＞

button to select the

menu.

2. You can check lamp usage hours

• Red warning lamp will light when it needs to be replaced. (Please refer page 10)
• When lamp usage hour exceeds the limit, red warning lamp is lit when the power

is turned on.

• Press the MENU button twice or the EXIT button to exit the menu screen

ꘀ

Prev.

Move

＜＞

Select

Keystone
Blank Image
Screen Capture
Lamp mode
Monitor Out

Communication
Set ID

Network Setting

High Altitude

Lamp Time

RGB1

Serial

＞

＜

＞

＜

＞

＜

＞

＜

＞

＜

ꕌ

ꕍ

Auto

＞

＜

0 Hr

Black

High bright