GE 100 User Manual

Recalling Test Results and Average

The GE100 Blood Glucose Meter is able to

store a maximum of 500 test results with time

and date. If your meter has stored 500 results, the newest test result will replace the oldest one. To
recall your test memory, start the meter without a test strip inserted.

automatically

1. Press the Main button to switch from the time mode to the Memory screen. You

will see the ”MEM” symbol in the upper left corner of the display. When you press
the Down button, the latest result will be displayed. By pressing the

button

sequentially, previous test results will be shown in chronological order. You will see
the sequence number in the lower right corner and the year in the lower left
corner of the display followed by date and time of the measurement.

Down

Note: The Up button is for reviewing the tests with the sequence number increasing, and the Down

button is for reviewing tests with sequence number decreasing. The sequence “1” is the latest result
while sequence “500” is the oldest test result.

2. To finish reviewing stored test results, press the Main button again. This will bring you to the Average

screen. By pressing the

button, the display shows "AVG" in the upper right corner of the display

and the average value for the day. By pressing the Up or Down button you will get to the 1-day, 7-
days, 14-days, 30-days and 90-days average of your blood glucose values. You will see the number of
the calculated days in the lower left corner and the number of the calculated readings in the lower
right corner.

Down

3. Non-Averaging set and canceled:
You may exclude unwanted or doubtful test results from the average calculation. After you finished your test in the

test mode, you can exclude the unwanted result. Keep pressing the

button until you see the symbol “NO AVG”

in the top right corner of the screen. Press the

button and the Main button simultaneously to confirm the

value as “Non average”. This value is flagged by the symbol “NO AVG” in the upper right corner of the screen.

To cancel a non-averaging setting, keep pressing the

button until the “NO AVG” symbol changes to “AVG” in

the upper right corner of the screen. To confirm this original status, simultaneously press the Main button to confirm
the “AVG” status. The value will be stored as a regular value and included in the average values.

Down

Recalling Test Results and Average

NOTE
- The average function requires that the correct time and date is set. If the time and date are not set correctly,

the average function will not be correct.

- The Non-averaging/re-averaging function only works in test mode and when you get a value. This action

cannot be performed in MEM mode.