HP ZBook 17 Service Manual
5.
Remove the service door (see
Service door on page 48
).
6.
Remove the optical drive (see
Optical drive on page 57
) or upgrade bay hard drive (see
Upgrade
bay hard drive on page 59
).
7.
Remove the keyboard (see
Keyboard on page 63
).
8.
Remove the top cover (see
Top cover on page 72
).
9.
Remove the display assembly (see
Display assembly on page 84
).
10.
Remove the graphics board fan/heat sink (see
Graphics board fan/heat sink assembly
on page 100
).
11.
Remove the processor heat sink (see
Processor heat sink on page 95
).
12.
Remove the audio/USB board (see
Audio/USB board on page 93
).
13.
Remove the Smart Card reader (see
Smart Card reader on page 92
).
14.
Remove the Expresscard assembly (see
ExpressCard assembly on page 91
).
When replacing the system board, be sure that the following additional components are removed from
the defective system board and installed on the replacement system board:
●
SIM (see
SIM on page 47
)
●
WLAN module (see
WLAN module on page 52
)
●
WWAN module (see
WWAN module on page 54
)
●
Solid-state drive (see
Solid-state drive (SSD) – mSATA on page 51
)
●
Hard drives (see
Hard drives, primary and secondary on page 49
)
●
Primary memory modules (see
Primary memory module on page 65
)
●
Expansion memory modules (see
Expansion memory module on page 62
)
●
Graphics board (see
Graphics board on page 103
)
●
Processor (see
Processor on page 98
)
Remove the system board:
1.
Pry off the plastic piece in the right rear corner above the RJ-45 connector (1).
Component replacement procedures
107