Sony CD-R/RW User Manual
Step 7: Mounting the Drive
Insert the CD-RW drive into computer front as shown, routing cables
accordingly. Secure drive to frame with appropriate screws.
accordingly. Secure drive to frame with appropriate screws.
Note:
Slide rails (not included) may be necessary if you cannot secure CD-RW
drive. Refer to your computer’s User’s Guide for more information.
Slide rails (not included) may be necessary if you cannot secure CD-RW
drive. Refer to your computer’s User’s Guide for more information.
Step 8: Connecting the Power Cable
Locate an available power supply cable, within computer, and connect it to
the rear of CD-RW drive as shown.
the rear of CD-RW drive as shown.
Note:
The power supply cable connector is designed to fit one way, do not force
it upside down, this could damage drive and void the warranty.
The power supply cable connector is designed to fit one way, do not force
it upside down, this could damage drive and void the warranty.
DC INPUT
GND 12V 10%
5V 5%
+
-
+
-
Step 6: Connecting the Drive
Attach flat SCSI cable to connector at rear of CD-RW drive.
Notes:
The 50 pin flat SCSI cable must be firmly attached with its red edge
(Pin 1) positioned next to the power supply connector.
The 50 pin flat SCSI cable must be firmly attached with its red edge
(Pin 1) positioned next to the power supply connector.
If computer has a Sound Card, an Audio Cable may be connected to the
rear of the CD-RW drive. Contact a local dealer if cable is required.
rear of the CD-RW drive. Contact a local dealer if cable is required.
Interface Connector
Pin 1
Power Supply Connector
Red Edge
Audio
Cable
Cable
Audio Out
Connector
Connector
SCSI
Flat Cable
Flat Cable
CD-R/W Drive Unit
Mounting Screws
Audio Cable
Flat Cable
Hardware Installation 13
12 Hardware Installation
Power Supply
Connector
Connector
Power Supply Cable