Honeywell 46-00869 User Manual
35
S
CANNER
O
PERATION
I
NDICATOR
D
ESCRIPTIONS
Diagnostic Indicator Display
There is a green colored (when
illuminated) single digit error code
display located to the left of the
scanner’s mirrored polygon (see
figure to the right).
illuminated) single digit error code
display located to the left of the
scanner’s mirrored polygon (see
figure to the right).
E
RROR
C
ODE
D
ESCRIPTION
0
RAM ERROR – The scanner’s Random Access Memory (RAM) is tested
as faulty. Return the unit for repair at an authorized service center.
as faulty. Return the unit for repair at an authorized service center.
1
PROGRAM ERROR – The scanner’s software program is failing. Return
the unit for repair.
the unit for repair.
2
INTERFACE ERROR – After power up and any application exit (e.g.
MetroSet, etc.), the scanner checks the interface hardware with that
chosen in configuration. If they do not agree, an interface error exists.
MetroSet, etc.), the scanner checks the interface hardware with that
chosen in configuration. If they do not agree, an interface error exists.
3
CONFIGURATION ERROR – The non-volatile configuration memory did
not agree with the data last saved. Default configuration data is then
used and the scanner continues operating.
not agree with the data last saved. Default configuration data is then
used and the scanner continues operating.
4
COMMUNICATION ERROR – The RS232 data line is being held active.
The scanner will abort attempts to enter configuration mode after a short
timeout.
The scanner will abort attempts to enter configuration mode after a short
timeout.
5
COPROCESSOR COMMUNICATION ERROR – The main
microprocessor is not communicating with the interface coprocessor.
Return the unit for repair at an authorized service center.
microprocessor is not communicating with the interface coprocessor.
Return the unit for repair at an authorized service center.
6
LASER ERROR – The laser in the scanning system denotes a failure.
Return the unit for repair at an authorized service center.
Return the unit for repair at an authorized service center.
7
MOTOR ERROR – The motor in the scanning system denotes a failure.
Return the unit for repair at an authorized service center.
Return the unit for repair at an authorized service center.
8
SCALE ERROR – The scanner is not communicating with the scale.
9
EAS ERROR – The scanner is not communicating with the EAS device.
Figure 33. Failure LED