Toshiba 24" Toshiba HD Ready TV Important Safety Instructions

English   - 22 -

Your TV is capable of finding and updating the 

firmware automatically via the broadcast signal or 

via Internet. 

On the main menu select 

System>Settings and 

then 

More. Navigate to Software upgrade and 

press the 

OK button. In Upgrade options menu 

select 

Scan for upgrade and press OK button 

to check for a new software upgrade.
If a new upgrade is found, it starts to 

download the upgrade. After the download is 

completed, a warning will be displayed, press 

OK button to complete software upgrade 

process and restart TV.

Your TV will search for new upgrades at 3:00 

o’clock if 

Automatic scanning option in the 

Upgrade options menu is set to Enabled and if 

the TV is connected to an aerial signal. If a new 

software is found and downloaded successfully, 

it will be installed at the next power on. 

Note: Do not unplug the power cord while led is blinking 

Make sure the power cord is plugged in securely 

to a wall outlet. Press the Power button on the TV. 

• Check if you have correctly tuned the TV.
• Low signal level can cause picture distortion. 

Please check antenna connections.

• Check if you have entered the correct channel 

frequency if you have performed manual tuning. 

• TV is not receiving any signal. Make sure the 

correct source has been selected.

• Is the antenna connected properly? 
• Is the antenna cable damaged? 
• Are suitable plugs used to connect the antenna? 
• If you are in doubt, consult your dealer.

• Check if the TV sound is muted. Press the Mute 

button or increase the volume to check.

• Sound is coming from only one speaker. Check 

the balance settings from Sound menu.

• The batteries may be exhausted. Replace the 

batteries.

• The batteries maybe inserted incorrectly. Refer 

to the section “Inserting the Batteries into the 

Remote”. 

• It is possible that no device is connected.
• Check the AV cables and connections from 

your device.

• Check the device is switched on.

To record a programme, you should first correctly 

connect a USB storage device to your TV, while 

the TV is switched off. You should then switch 

on the TV to enable the recording feature. If 

you cannot record, check the storage device is 

correctly formatted and there is sufficient space.

If a “USB storage device writing speed too slow to 

record” message is displayed on the screen while 

starting a recording, try restarting the recording. 

If you still get the same error, it is possible that 

your USB storage device does not meet the 

speed requirements. Try using a different USB 

storage device.