Toshiba 24" Toshiba HD Ready TV Important Safety Instructions
English - 11 -
Connections
Connector
Type
Cables
Device
Scart
Connection
(back)
VGA
Connection
(back)
SIDE AV
PC/YPbPr
Audio
Connection
(side)
YPbPr/PC Audio Cable
HDMI
Connection
(back)
SPDIF
SPDIF
(Coaxial Out)
Connection
(back)
SIDE AV
Side AV
(Audio/Video)
Connection
(side)
AV Cable
HEADPHONE
Headphone
Connection
(side)
PC to YPbPr
YPbPr Video
Connection
(back)
PC to YPbPr Connection Cable
USB
Connection
(side)
CI
Connection
(side)
CAM
module
LAN
Ethernet
Connection
(back)
LAN / Ethernet Cable
NOTE: When connecting
a device via the YPbPr or the
Side AV input, you must use
a connection adapter cable.
See the illustrations on the
left side. You can use YPbPr
to VGA cable to enable YPbPr
signal via VGA input. You
cannot use VGA and YPbPr at
the same time. To enable PC/
YPbPr audio, you will need to
use the Side AV input with a
YPbPr/PC audio cable for
audio connection, using the
Side AV connection cable’s
RED and WHITE inputs. If an
external device is connected
via the SCART socket, the TV
may automatically switch to
EXT1 mode. When receiving
DTV channels (Mpeg4 H.264)
or while in Media Browser
mode, output will not be
available via the scart socket.
When using the wall mounting
kit (available from a third
party in the market, if not
supplied), we recommend
that you plug all your cables
into the back of the TV before
mounting on the wall. Insert
or remove the CI module only
when the TV is SWITCHED
OFF. You should refer to the
module instruction manual
for details of the settings.
The/Each USB input of your
TV supports devices up to
500mA. Connecting devices
that have current value above
500mA may damage your TV.
When connecting equipment
using a HDMI cable to your
TV, to guarantee sufficient
immunity against parasitic
frequency radiation, you have
to use a high speed shielded
(high grade) HDMI cable with
ferrites.
If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making
any connection. After the connection is done, you can turn on the units and use them.