Intel express 550t User Manual
500.bok : 50001 11 Fri Sep 11 14:52:16 1998
11
C H A P T E R 1
Intel Express 550T Routing Switch
RJ-45 connector pin
assignments
assignments
The RJ-45 ports on the front of the switch have the following pin as-
signments:
signments:
Connecting a device to
the RJ-45 ports
the RJ-45 ports
To connect a workstation compatible with IEEE 802.3 (Ethernet Ver-
sion 1.0 and 2.0) or a fast access device (such as a server) to the
switch’s RJ-45 ports using UTP cable (Category 5):
sion 1.0 and 2.0) or a fast access device (such as a server) to the
switch’s RJ-45 ports using UTP cable (Category 5):
1
Make sure that the device has a 100Mbps (100Base-FX or 10/
100Base-TX) network interface card installed.
100Base-TX) network interface card installed.
If not, use your network interface card’s documentation to
install and configure it correctly.
install and configure it correctly.
2
If your workstation is fitted with an RJ-45 interface then there is
no problem. However, it is possible to attach to other connector
types using an appropriate adapter. For example, use a UTP/
10Base-FL adapter for fiber connections
no problem. However, it is possible to attach to other connector
types using an appropriate adapter. For example, use a UTP/
10Base-FL adapter for fiber connections
3
Connect one end of the UTP cable to an RJ-45 port on the
switch.
switch.
According to IEEE 802.3, the cable length must not exceed 100
meters (approximately 325 feet).
meters (approximately 325 feet).
4
Connect the other end to the 100Base-TX connection on the
device.
device.
Cable for the Console Port
If you connect a PC (via the Console Port), then use a null-modem ca-
ble.
ble.
Connecting the Power
Introduction
After connecting the devices to the switch, connect the power cable.
There are certain practical and safety considerations to be made be-
fore powering the switch on.
There are certain practical and safety considerations to be made be-
fore powering the switch on.
Pin number
Function
1
RX+
2
RX-
3
TX+
6
TX-