Siemens rs232 User Manual

gigam101.fm5

21.4.99

Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1 

There are two LEDs and a black button on the front of the Gigas-

et M101 Data unit.

Press the button on a powered base-type device for 10 seconds. 

The two LEDs blink in sequence, thus indicating that the device 

is in logon mode. Logon mode is automatically deactivated after 

successful logon or after 10 minutes: the blinking stops.

Press and hold down the button on the device that has been dis-

connected from the mains. Connect the device to the power 

supply while holding the button down. LED 2 lights up after 10 

seconds. This LED goes out in another 10 seconds indicating 

that the reset operation has been successful. The button can 

then be released.

LED 1 indicates stand-by mode:

LED 2 indicates the status of the transmission route on the

V.24/RS232 interface:

LED 1 blinks

The station is searching for the part-

ner or has not been registered.

LED 1 is constantly il-

luminated

The partner was found, the transmis-

sion route is on stand-by.

LED 2 off

No data transfer

LED 2 flickers

Data transfer active