Siemens gigaset c475 ip User Manual

Using several handsets
Registering handsets

Gigaset C470-475 IP / EN for IM-Ost / A31008-xxxx-xxxx-x-xxxx / T-NetBox_SAG-registration.fm / 18.12.07

Ve

rs

ion 2.

1, 

08.0

1.20

07

You can register up to six handsets to your base station.
When you register a new Gigaset handset, the base station transfers the following entries 

to its local directory to enable you to use online directories on your new handset:

u

for the currently active online directory (page 53)

u

for the currently active online classified directory (page 53)

u

 for the Gigaset.net directory (page 42)

Precondition: The handset can send and receive directory entries (see handset operating 

instructions).
Successful registration is acknowledged with a 

 for this rea-

son.

Before you can use your handset, you must register it to a base station.
You must initiate handset registration on the handset and on the base station.
The handset will change to idle status if registration was successful. The handset's internal 

number is shown in the display e.g. 

. If not, repeat the procedure. Registration can take 

up to one minute. 

¤

v 

¢

Ð

 

¢

  

¢

on the handset. 

¤

Enter the system PIN of the base station (the default is 0000) and press 

. The display 

shows e.g. 

 and flashes.

¤

Within the next 60 seconds press and hold (for approx. 3 seconds) the registration/pag-

ing key (page 2) on the base station. 

The handset is assigned the lowest available internal number (1-6). If a number of hand-

sets are registered on the base station, the internal number appears in the display after reg-

istration, e.g. 

. This means that the internal number 2 was assigned to the handset. 

– If a number of handsets are registered on your base station, you can simultaneously make two 

calls via the Internet and one via the fixed line network Up to two additional internal connections 

are also possible. 

– Selecting the connection via the talk key (page 31) is not supported on GAP handsets. Therefore, 

if you enter a number without a line suffix and without defining a dialling plan for the phone 

number, it will be dialled via 

(page 117). If you enter a "*" (star) at the end of the phone 

number, it will be dialled via the non-default connection. 

– After registration, all the phone numbers for the phone will be assigned to the handset as receive 

numbers. It will use the fixed line network number and the first VoIP number as send numbers. 

For how to change the assignments, see page 144.