KitchenAid KDRS483VSS Installation Guide

Use this method for:

 

■

New branch-circuit installations (1996 NEC)

 

■

Mobile homes

 

■

Recreational vehicles

 

■

In an area where local codes prohibit grounding through 

the neutral.

1.  Remove the ground-link screw from the range frame. 

Save the ground-link screw. Bend the ground link away 

from the range so that it does not contact the range.

2.  Connect the green ground wire from the power supply 

cord to the range using the ground-link screw. The ground 

wire must be attached first and must not contact any other 

terminal.

3.  Use a 

1

/

4

" nut driver to remove the hex washer head screws 

from the terminal blocks.

4.  Connect the neutral (center) wire to the center terminal 

connector using one of the hex washer head screws.
Securely tighten screw for proper electrical connection.

5.  Connect the other 2 wires (lines 1 and 2) to the outer 

aluminum terminal blocks.

6.  Securely tighten screws for proper electrical connection.
7.  Tighten strain-relief screws.
8.  Replace terminal block cover.

Use this method only if local codes permit connecting cabinet-

ground conductor to neutral wire of power supply cord.
1.  Use a 

1

/

4

" nut driver and remove the hex washer head 

screws from the aluminum terminal blocks.

2.  Connect the neutral (center) wire to the center terminal 

connector using one of the hex washer head screws. 

Securely tighten screw for proper electrical connection.

3.  Connect the other 2 wires (lines 1 and 2) to the outer 

terminal screws on the terminal block.

4.  Tighten strain-relief screws.
5.  Replace terminal block cover.

Install Water Filtration System

(on some models)

1.  Install the water filter near the cold water supply pipe under 

the kitchen sink to filter the cold water.
IMPORTANT: Be sure to allow a minimum clearance of 

1

1

/

2

" (3.8 cm) under the filter system for removing the filter 

cartridge.
Make sure that the water filter assembly is installed in the 

upright position.

NOTE: For unique installations, contact a licensed plumber.
In Massachusetts, a licensed plumber is required and the 

Commonwealth of Massachusetts Plumbing Code 248-CMR 

will be adhered to.