LG 31160 User Guide
E
N
G
L
IS
H
19
5. Carefully remove any accumulated
string, hair, etc. from the agitator and
the agitator area.
the agitator area.
To reinstall the cover, hook the front
edge of the cover into place, rotate it
down until the tabs clip into place, then
turn the retainers to the locked position.
edge of the cover into place, rotate it
down until the tabs clip into place, then
turn the retainers to the locked position.
Agitator Maintenance (cont.)
CARE & CLEANING
WARNING
Electrical shock and personal
injury hazard.
injury hazard.
Always unplug power cord from
electrical outlet before performing
any service on vacuum cleaner.
Failure to do so could result in
electrical shock or personal injury
from vacuum cleaner suddenly
starting.
electrical outlet before performing
any service on vacuum cleaner.
Failure to do so could result in
electrical shock or personal injury
from vacuum cleaner suddenly
starting.
If the belt breaks, follow the steps below
to replace the agitator belt.
to replace the agitator belt.
To Replace the Belt:
1. Remove the agitator brush cover as
described on page 18.
2. Lift the agitator straight out.
3. Remove the
old belt. Make
sure no pieces
of the broken
belt are
trapped in the
agitator or drive
pulley area.
sure no pieces
of the broken
belt are
trapped in the
agitator or drive
pulley area.
4. Hook the new
belt over drive
pulley.
pulley.
5. Fit the belt end of the agitator through
the belt, making sure the belt is
aligned with the pulley section of
the agitator.
aligned with the pulley section of
the agitator.
6. Lower the agitator into place, making
sure the oval shaped tabs fit into the
indents on the vacuum cleaner.
indents on the vacuum cleaner.
7. Reinstall the agitator brush cover as
described above.
For a replacement belt, order Kenmore
belt MAS37628301.
belt MAS37628301.
Replacing the Agitator Belt
78017_Kenmore vac_EN_final 10/17/07 9:00 AM Page 19