GE jx1827cb Installation Instruction

Trim Frame

1

Bottom Duct

1

Side Duct

1

1” Screws

6

(4 required, 2 extra)

1/2” Screws 

15

(11 required, 4 extra)

Anti-Tip Bracket 

1

Bottom Bracket 

1

Upper Duct 

1

Template

1

or

Visit our Website at:

Read these instructions completely and carefully.

IMPORTANT –

Save these 

instructions for local inspector’s use.

IMPORTANT –

Observe all 

governing codes and ordinances.

Note to Installer –

Be sure to leave these

instructions with the Consumer.

Note to Consumer –

Keep these 

instructions for future reference.

Unplug the microwave oven before attempting

installation of this kit.

• Skill level

– Installation of this appliance requires basic

mechanical and electrical skills.

• Completion time

– 1-3 hours

Proper installation is the responsibility of the installer. 

Product failure due to improper installation is not

covered under the Warranty.

This kit is UL listed for installation alone or over any

General Electric/Hotpoint/RCA single electric wall

oven.

Phillips screwdriver

Pencil

Tape measure

Awl or punch

Drill with 

7

⁄

64

″

bit or #35

WARNING –

Before beginning the

installation, switch power off at service panel and lock

the service disconnecting means to prevent power

from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten

a prominent warning device, such as a tag, to the

service panel.