Sony vgn-sr410j Installation Instruction
VGN-SRxx Series Hard Disk Drive
Replacement Instructions
FOR TECHNICAL SUPPO RT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N
Rev. X3
1/2
Step 1. Prepare the Computer.
CAUTION
:
Make sure the
computer is turned off, the lid is closed,
and the AC Adapter is disconnected.
Failure to do so can result in damage to
the computer.
and the AC Adapter is disconnected.
Failure to do so can result in damage to
the computer.
Place the computer upside down on a
protected surface with the front edge
facing you.
Step 2.
Remove the Battery Pack.
1. Slide the left battery tab to the
unlock position.
2. With your right thumb, slide the
right battery tab in the release
direction and hold.
direction and hold.
3. Remove the battery by lifting the
side where the arrow is pointing.
(HDD Removal) Steps 3-7
Step 3. Locate the HDD Bay. Using the
enclosed magnetic screwdriver, loosen the
two (2) screws securing the HDD access
cover.
enclosed magnetic screwdriver, loosen the
two (2) screws securing the HDD access
cover.
To remove the HDD access cover, start by
lifting from the side where the screws held
it in place.
lifting from the side where the screws held
it in place.
These easy instructions are intended to guide you through the replacement process. If you need additional
help, please call 1-866-651-7669 for technical support from 9:00 am to 11:00 pm EST.
help, please call 1-866-651-7669 for technical support from 9:00 am to 11:00 pm EST.
ü
To avoid electric shock, please make sure product is turned off and AC Adaptor is disconnected
from the power source. Remove jewelry before you begin work to avoid scratching the surface of
your notebook computer.*
from the power source. Remove jewelry before you begin work to avoid scratching the surface of
your notebook computer.*
ü
Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer’s case.*
computer’s case.*
ü
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o
Hold parts by the ed ges, away from exposed circuitry when possible.
o
Do not walk around excessively as this promotes static build-up.
ü
The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of
the computer under these procedures. The terms of your Sony limited warranty continue to apply.
the computer under these procedures. The terms of your Sony limited warranty continue to apply.
IMPORTANT!
PLEASE READ BEFORE YOU START
HDD Bay
Push left tab in the unlock position
Lift to remove
1.
2.
3.