GE zdp30n4dss Specification Guide

These ranges are factory set for either natural gas or
liquid propane gas.

30" Natural Gas Model:
ZDP30N4YSS–4 gas burners

30" Liquid Propane Gas Model:
ZDP30L4YSS–4 gas burners 

Accessory Requirements:
All models require the installation of a backguard. A
backguard should be ordered at the same time as the
range. Both must be on site at the time of installation.

Order one backguard for 30" models:
ZX1B30YSS–1-1/2" high backguard 
(required for island installations)
ZX12B30YSS–9" high backguard
ZX22B30YSS–22" high backguard with warming rack 
(2 piece)

Advance Planning:
Refer to dimensional drawings for appropriate placement
and necessary clearances when planning 
the installation.

• Cabinetry cannot be installed directly above the range.

• This range requires the installation of a vent hood,

30" to 36" above the surface.
– The vent hood must be at least 24" deep.
– The vent hood must be the same width as the range.
– The vent hood must provide at least 600 CFM and 

up to 800 CFM.

• Working areas adjacent to the range should have 

18" minimum clearance between countertop and
cabinet bottom.

• Clearance between range and side wall or combustible

material must be at least 12" on each side. 

21-1/4"

12"

1-1/2"

35-1/4"-36-3/4"

26-3/4"

29-7/8"

Available Backguards

ZX22B30YSS

ZX12B30YSS

ZX1B30YSS

Listed by
Underwriters
Laboratories

For answers to your Monogram,

® 

GE Profile

™

or 

GE appliance questions, visit our website at
GEAppliances.com or call 
GE Answer Center

®

service, 800.626.2000.