3M eg3 User Manual
Docking Customizing set-up parameters in DMS
Communicating & downloading data
053-644, Rev E
Page 23
eg4 & eg3
23
4. For first time use of a docking station, Welcome to the found new hardware
wizard will appear (see Figure 2-8). Select No and press Next through the
remaining wizard. At the end of the wizard, press Finish.
remaining wizard. At the end of the wizard, press Finish.
This will install the hardware components associated with your EdgeDock1 and/or
EdgeDock5.
EdgeDock5.
NOTE: If you have more than one EdgeDock1 or EdgeDock5, this wizard will
appear for each new dock which is connected to your pc.
appear for each new dock which is connected to your pc.
Figure 3-5: New Hardware wizard for Edge Dock
Customizing and saving set-ups are performed via DMS. The following sections discuss each
of the setup screens and explain how to save and send the parameters to the dosimeter(s).
NOTE: The following DMS settings apply to the eg4 model. If you are also using other models
such as the eg3/eg4 and have them docked in a 5-bay charger, they will appear in the “Edge
Bay Charger” tree section. If you are also using other models (eg5) and have them docked in
such as the eg3/eg4 and have them docked in a 5-bay charger, they will appear in the “Edge
Bay Charger” tree section. If you are also using other models (eg5) and have them docked in
a 5-bay charger, they will appear in the “Edge Bay Charger” tree section with a icon. To
select Edge 5 models, first select the Model (on the left-hand panel) and then click the refresh
button. The instruments are selected by clicking in the checkbox(es).
select Edge 5 models, first select the Model (on the left-hand panel) and then click the refresh
button. The instruments are selected by clicking in the checkbox(es).
Example of EdgeDock-5
with Edge 4 selected in the
first bay.
with Edge 4 selected in the
first bay.