GE PTC22MBMWW Leaflet
TM
Specification Revised 1/03
PTC22MBM – GE Profile
™
21.9 Cu. Ft. CustomStyle
™
Top-Freezer Refrigerator
Case Dimensions (in inches/cm.)
69-7/8
68-3/4
35-3/4
28-3/8
23-3/4
61
26-3/4
38-1/4
25"
Counter
Top
Counter
Top
Electrical
Water
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
(1/2" Gap + 1/4"
Wall Plates)
24-1/2"* Side panels
24"
Cabinet
Cabinet
8' Ceiling
13" to 14"
Cabinet
Cabinet
12"
Soffit
Soffit
70-1/4"*
36"
24"
Standard, New Construction and Replacement Installation
Installation Tips to Maximize the Built-In Look
• All wall/floor moulding should be removed prior to installation.
• Water recess on rear wall recommended to prevent water line damage.
• All wall/floor moulding should be removed prior to installation.
• Water recess on rear wall recommended to prevent water line damage.
48" minimum length 1/4" diameter water line tubing recommended.
• When possible, recess both copper water line and electrical outlet.
(See local codes)
• Front and rear leveling legs are adjustable for the built-in look.
(See owner’s manual)
Handle Side Clearance
– At least 2" (51 mm) on the handle side for fingertip clearances.
Top and Bottom Clearance
– At least 3/16" (4.75 mm) at the top and bottom edges to allow for trim flange.
Hinge Side Clearance
– The installation of 3/4" (19 mm) thick side panels requires less clearance
because the space between the door and adjacent countertop is wider.
• To avoid door contact to countertop consider:
– Miter the corner of the adjacent countertops 45°, or pull the refrigerator
forward enough to avoid contact.
Rough-In Dimensions (in inches/cm.)
IMPORTANT:
Before finalizing specifications for your GE Profile Performance
Before finalizing specifications for your GE Profile Performance
™
CustomStyle
™
Refrigerator, Please NOTE:
• A minimum of 36" is required for refrigerator installation
• Be sure to allow for 1/2" or 3/4" side panels in addition to the 36" minimum
• Be sure to allow for 1/2" or 3/4" side panels in addition to the 36" minimum
Top View
Front View
R
Total volume and shelf
area are calculated by the
Association of Home
Appliance Manufacturers’
standards.
area are calculated by the
Association of Home
Appliance Manufacturers’
standards.
Listed by
Underwriters
Laboratories
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile
™
or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.