Jenn-Air TC507 User Manual

Page of 28
7
Cabinet-front mounting
7. Grasp sides of compactor drawer and place bottom of 
drawer into tracks. Lift at the handle so drawer will go over 
drawer stops. Close drawer. Check to see if drawer opens 
freely. If the toe plate rubs against floor, see “Adjusting the 
Toe Plate” for further instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance 
may be changed as follows:
1. Mark on each side of the toe plate the amount of toe plate 
that rubs the floor covering.
2. Remove the drawer from the unit. (See Step 3 in the 
“Unpacking” section.)
3. Use a ruler and a pencil or chalk to draw a line between the 
marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat 
steps 1-4.
Air Freshener
The solid air freshener system is designed to help control odors 
that might develop in the trash. An air freshener disc can be 
purchased in department stores (not sold with compactor). Place 
the disk-shaped solid air freshener into the air freshener 
compartment. The air freshener should last 4 to 6 weeks. It is 
used more rapidly when the temperature is high or the air is very 
dry.
Changing the Decorative Panel
There are three options for changing the decorative panel: 
Order an acrylic panel 
Create a custom panel for use with a trim kit
Create a custom panel for installation without trim
To order an acrylic panel or a trim kit, see the “Assistance or 
Service” section for information or call the toll-free number on the 
cover. 
Trim kit panel dimensions
Use these dimension drawings to create a custom panel for use 
with a trim kit. Then, follow the installation instructions provided 
with the kit. 
Flat panel: 
³²
 in. (5.6 mm) thick panel is required. This is the 
same thickness as a standard 
¹₄ in. plywood or paneling.
Raised panel: The outer section of panel must be 
³²
 in. (5.6 mm) 
thick to fit into trim. Design raised panel sections using 
dimensions shown above.
1. Mounting clip
2. Cabinet
3. Retaining bracket
4. Mounting screw
1
4
3
2
1. Raised panel or decorative trim
2. Outer section of panel
23
    
"
13
16
(60.5 cm)
14   "
5
8
(37.2 cm)
23    "
13
16
(60.5 cm)
1   "
1
4
(32 mm)
14   "
5
8
(37.2 cm)
"
7
32
(5.6 mm)
"
5
16
(8 mm)
both sides
1
2
"
5
16
(8 mm)