GE 164D2966P205-1 User Manual

37

“F–AND A NUMBER

• This is a function error code. Press CLEAR/OFF. Allow the oven to cool one

OR LETTER” FLASH

hour. Place the oven back into operation.

IN THE DISPLAY

• Disconnect all power to the oven for 5 minutes and then reconnect power. If the 

failure code repeats, call for service.

CONTROL SIGNALS AFTER

• This is reminding you to press BAKE or CONVECTION BAKE and then enter 

ENTERING COOKING TIME

a bake temperature.

OR DELAY START TIME

• This is reminding you to enter a bake temperature after having pressed BAKE  

or CONVECTION BAKE.

DISPLAY GOES BLANK

• The circuit breaker in your house has been tripped, or a fuse has been blown.

DISPLAY FLASHES

• Power failure. Reset the clock.

UNABLE TO GET THE

• BAKE and BROIL HI/LO must be pressed at the same time and held for

DISPLAY TO SHOW “SF”

2 seconds.

“PROBE” APPEARS IN

• The probe is not inserted properly into the oven receptacle or food.

THE DISPLAY

• This is reminding you to enter a probe temperature after plugging in the probe.

“LOCK DOOR” FLASHES

• Oven door not closed after self-clean cycle is selected. 

“LOCKED DOOR” FLASHES

• Door is still locked and you are trying to enter an oven cooking operation.

OVEN LIGHT DOES

• The light bulb is loose or defective. Tighten or replace.

NOT WORK

• The pad operating the oven light is broken. Call for service.

OVEN WILL NOT SET A

• Oven temperature is too high to set self-clean operation. 

SELF-CLEAN CYCLE

Allow the oven to cool to room temperature and reset the controls.

• The probe is plugged into the outlet in the oven. Remove the probe from

the oven.

OVEN NOT CLEAN

• Oven controls not set properly. See the Operating the Self-Cleaning 

AFTER CLEAN CYCLE

Oven section.

• Heavily soiled ovens require 4 to 5 hours of clean time.

• Heavy spillovers should be cleaned up before starting clean cycle.

DOOR WILL NOT 

• When the temperature has fallen below the locking temperature door can

OPEN AFTER 

be opened. 

SELF-CLEAN CYCLE