GE PS978STSS Leaflet

For answers to your Monogram,

® 

GE Profile

™

 or  

GE

®

 appliance questions, visit our website at 

geappliances.com or call GE Answer Center

®

 

service, 800.626.2000.

PS978STSS 

GE Profile

™ 

Slide-In Double Oven Electric Range

 

220455

All GE ranges are equipped with 

an Anti-Tip device. The installation 

of this device is an important, 

required step in the installation  

of the range.

Listed by 

Underwriters 

Laboratories

Note: To reduce the possibility of scorching the side walls above the countertop 

when no load is present on burners, it is recommended that a minimum 6" 

spacing from adjacent side wall be allowed for possible extended high-heat 

element operation.
Receptacle Locations: For all 30" Slide-In Ranges locally approved flexible 

service cord or conduit must be used because terminals are not accessible 

after range installation. See shaded area in drawing for location of electrical 

outlet box. Recommended outlet locations allow range to be installed directly 

against rear wall. 

240V 14.4
208V 10.8

240V 40 Amps
208V 40 Amps

Installation information: Before installing, consult installation instructions 

packed with product for current dimensional data. 

A. Make sure the wall covering, countertop, flooring and cabinets around the range can 

withstand the heat (up to 200°F) generated by the range. 
B. Allow 30" minimum clearance between surface units and bottom of unprotected wood or 

metal cabinet, or allow a 24" minimum when bottom of wood or metal cabinet is protected 

by no less than 1/4" thick flame retardant millboard covered with not less than No 28 MSG 

sheet metal, (.015"), .015" thick stainless steel, .024" aluminum or .020" copper. Acceptable 

electrical outlet area. Orient electrical receptacle so the length is parallel to floor.
C. This appliance has been approved for 0" spacing to adjacent surfaces above the 

cooktop. However, a 6" minimum spacing to surfaces less than 15" above the cooktop 

and adjacent cabinet is recommended to reduce exposure to steam, grease splatter 

and heat. To reduce the risk of burns or fire when reaching over hot surface elements, 

cabinet storage space above the cooktop should be avoided. If cabinet storage space is 

to be provided above the cooktop, the risk can be reduced by installing a range hood that 

projects at least 5" beyond the front of the cabinets. Cabinets installed above the cooktop 

must be no deeper than 13".

Note: Use a 4'power cord to prevent 

interference with unit when installing.