HP (Hewlett-Packard) ML110 G6 User Manual

 

 

Removal and replacement procedures  64  

 

 

System fan 

A new system fan can be installed to allow the server to operate properly in case the default system 

fan becomes defective. 

To replace the system fan:  

 

 

CAUTION:

 Be sure to support the system fan with your hand when removing screws from the 

chassis. The fan could fall onto the system board or an accessory board causing damage if not 

supported. 

1. 

Perform the pre-installation procedure. 

2. 

Remove the default system fan: 

a. 

Disconnect the system fan cable from its system board connector (1). 

b. 

From inside the chassis, slightly detach the fan from the chassis, and then pull the four rubber 
bolts through their chassis holes (2).  

c. 

Remove the fan from the chassis (3). 

 

 

3. 

Remove the new system fan from its protective packaging.