Manualsbrain.com
  1. Manuals
  2. Brands
  3. HP (Hewlett-Packard)
  4. ML110 G6
  5. User Manual

HP (Hewlett-Packard) ML110 G6 User Manual

Download
Page of 115
 
 
Removal and replacement procedures  40  
 
 
Hard drives 
The four lower drive bays can accommodate 3.5-inch non-hot-plug SAS or SATA hard drives. The 
following drive capacities are supported.  
• 
Non-hot-plug SAS HDD – 146-, 300-, 400-, and 450-GB 
• 
Non-hot-plug SATA HDD – 160-, 250-, 500-, and 750-GB; 1-TB 
 
 
IMPORTANT:
 SAS hard drives require that you also install a SAS controller board. This board 
should be installed in the full-height/full-length PCIe Gen1 x8 expansion slot. For more information 
about installing the SAS controller board, see 
To install a hard drive:    
1. 
Perform the pre-installation procedure. 
2. 
Remove the HDD EMI shield.  
a. 
Loosen the HDD EMI shield thumbscrew (1). 
b. 
Slide the shield slightly to the right to release the shield tabs (2), and then pull it away from 
the chassis (3). 
 
 
3. 
Do one of the following: 
○ 
If you intend to replace an old hard drive, proceed to step 4.  
○ 
If you intend to install an additional hard drive, proceed to step 5.