Schneider Electric 17S Series User Manual
110
Wiring a Sub-D Connector with Shielding
Wiring the Sub-D
Connector
Connector
If you construct your own Sub-D connector with shielding, please do so according
to the following procedure which correlates to the eight steps in the diagram that
follows this procedure.
to the following procedure which correlates to the eight steps in the diagram that
follows this procedure.
Continued on next page
Step
Action
1
Carefully remove about 25mm of the outer covering while taking care not to
damage the braided shield.
damage the braided shield.
2
Push the exposed braided shield back over the outer covering
.
3
Leave the first 12mm of the braided shield free and insulate the rear portion
with shrink tubing.
with shrink tubing.
4
Carefully strip about 5mm from the individual wires while taking care not to
damage the copper strands.
damage the copper strands.
5
Verify pin assignments then solder the individual wires to the solder cups of the
Sub-D connector. (Check the wire colors.)
Sub-D connector. (Check the wire colors.)
6
Attach the cable to the connector housing strain relief; the strain relief must
have good contact with the exposed shielding of the cable.
have good contact with the exposed shielding of the cable.
7
Place the knurled screws in position.
8
Place the Sub-D connector in the groove of the half-housing (pin 1 at bottom)
and press the two halves together.
and press the two halves together.
Note: Once the halves of the housing have been pressed together, they cannot
be opened without damaging them.
be opened without damaging them.