Intel 249323-003 User Manual
LXD9785 PQFP Demo Board with FPGA for SS-SMII (Fiber)-to-MII Conversion
12
Development Kit Manual
Document #: 249323
Revision #: 003
Rev. Date: January 24, 2002
3.0
Quick-Start Checklist
Use this quick-start procedure for easy setup of the LXD9785 PQFP MII Demo Board. This
procedure sets all ports to the default condition (100 Mbps and full-duplex capabilities).
procedure sets all ports to the default condition (100 Mbps and full-duplex capabilities).
1. Set the jumpers in accordance with
.
3. Connect the eight Demo Board MII ports to the SmartBits test box via MII connector/cables.
Male-to- male connectors are required to interface the SmartBits test box to the LXD9785
PQFP MII Demo Board and are available from Newark (.5m cable - Newark P/N 91F9746).
PQFP MII Demo Board and are available from Newark (.5m cable - Newark P/N 91F9746).
4. Connect the fiber ports to external NIC cards via fiber cables. Each NIC card plugs directly
into the SmartBits test box.
5. Connect +2.5V DC power to VCC and a +3.3V DC power supply to VCCIO and VCC-EXT.
6. With the Demo Board appropriately configured, apply power to the LXD9785 PQFP MII
Demo Board and press Reset switch S4.
7. Proceed with evaluation as desired.
Table 1. Quick-Start Jumper Settings
Jumper / Label
Setting
Configuration
JP1 / MDIO
Jumper Pins
2 & 3
2 & 3
Routes MDIO through Port 0 MII Connector.
JP2 / MDC
Jumper Pins
2 & 3
2 & 3
Routes MDC through Port 0 MII Connector.
JP12 / SD Interface
Open
Enables 3.3V SD Fiber interface.
JP13
Jumpered
Provides voltage to Fiber transceivers.
JP15
Jumper Pins
2 & 3
2 & 3
Enables 1x8 mode.
JP16
Jumper Pins
1 & 2
1 & 2
Enables 2x4 mode.