IBM 343 User Manual
33
4 Configuration Software and Utilities
This chapter describes the Power-On Self-Test (POST) and server configuration utilities. The table
below briefly describes the utilities.
below briefly describes the utilities.
Table 11. Configuration Utilities
Utility
Description and brief procedure
Page
BIOS Setup
If the system does not have a diskette drive, or the drive is
disabled or incorrectly configured, use Setup to enable it.
disabled or incorrectly configured, use Setup to enable it.
Or, you can move the CMOS jumper on the server board from the
default setting (Protect CMOS memory) to the Clear setting; this
will allow most server configurations to boot. Then run the SSU to
configure the server.
default setting (Protect CMOS memory) to the Clear setting; this
will allow most server configurations to boot. Then run the SSU to
configure the server.
BIOS Upgrade Utility
Use to upgrade the BIOS.
System Setup Utility
(SSU)
(SSU)
Use for viewing and clearing the system event log, viewing the
system management FRU information, or viewing the system
management SDR repository.
system management FRU information, or viewing the system
management SDR repository.
FRUSDR Load Utility
Use to update the Field Replacement Unit (FRU), Sensor Data
Record (SDR), and SM BIOS (SMB) flash components.
Record (SDR), and SM BIOS (SMB) flash components.
Firmware Update Utility
Use to update the Firmware.
Using the Adaptec SCSI
Utility
Utility
Use to configure or view the settings of the SCSI host adapter and
onboard SCSI devices in the server.
onboard SCSI devices in the server.