Furuno FS-1575 FS-2575 FS-5075 User Manual
7-1
7.
NBDP SYSTEM OVERVIEW
7.1
How to Turn on the NBDP System
Turn on the terminal unit and the printer with their respective power switches.
Note 1: To power on the system, turn on the control unit then turn on the NBDP ter-
minal unit.
minal unit.
Note 2: The printer PP-510 prints messages. Refer to its operator's manual for oper-
ation.
ation.
7.2
Description of Equipment
7.2.1
Terminal unit
The terminal unit is a visual display incorporating a floppy disk drive (for IB-583) or an
SD card drive (IB-585). To adjust the brilliance, press the Alt key while pressing the
F6 key to lower the brilliance; the F7 key to raise it. 8 levels of brilliance are available
for IB-583 and 11 levels for IB-585.
SD card drive (IB-585). To adjust the brilliance, press the Alt key while pressing the
F6 key to lower the brilliance; the F7 key to raise it. 8 levels of brilliance are available
for IB-583 and 11 levels for IB-585.
When the terminal unit is turned on, the communication status screen, shown on the
next page, appears. This is where all phases of telex communications begin.
next page, appears. This is where all phases of telex communications begin.
TERMINAL UNIT IB-583
Power switch
Floppy disk drive
PRINTER PP-510
Power switch
TERMINAL UNIT IB-585
Power switch
SD card drive
The power switch
backlights for
IB-583 and IB-585
light in green
during power-on.
backlights for
IB-583 and IB-585
light in green
during power-on.
USB connector (Connect the
keyboard here.)
keyboard here.)